Mud System Physics V1.2.8

V1.2.8.0
– Added sounds for tire inflation and puncture repair sounds.
– Dirt speed limits have been increased.
– The jack is less likely to climb onto equipment when placed, installation detection has been improved
– The jack has been given a higher lift.
– The jack can now be moved by opening the jack hud
– Adaptation to the FS25_TractorTerrainDynamics mod has begun.

V1.2.7.0
– Added tire puncture mode. (you can turn it off in the mod settings if you don’t need it) With a punctured wheel, the vehicle drives slower and pulls towards the punctured wheel. The wheel can be replaced manually by going to the broken wheel, pressing R, putting the wheel on the ground, sealing it, picking it up and putting it back.
– A technically new rule has been introduced. A physical coordinator so that possible modes of the mod do not multiply the transmitted data by themselves and the like. (technical part)
– The speed limit in mud has been improved, now mud has become a stronger brake on vehicles.
– Various minor edits.

The puncture mechanics work like this: (video here https://youtu.be/yVw4OckrNWk)

📌 Tire puncture
• Each vehicle wheel has a 2% chance of getting a puncture. That is, the mechanics will not be too aggressive.
• Perhaps, if the majority wishes, later I will make this chance a separate setting or simply increase/lower it.
• On average, a puncture should occur approximately once every 50 km. But chance is an insidious thing 😅 These same 2% may work immediately, or they may not appear for a very long time. Everything is completely random.

📌 What happens during a puncture?
• The equipment begins to slow down.
• The steering wheel pulls towards the broken wheel.

📌 Repair process
1⃣ Get out of the tractor.
2⃣ Take the jack (R – all actions are performed with the R key).
3⃣ Install the jack (R).
4⃣ Approach him and press R again.
5⃣ HUD opens: ⬆ raise / ⬇ lower.
6⃣ Raise the equipment to the desired height (minimum) and click “Done”.

📌 Removing the wheel
• Find the broken tire and press R.
• The wheel is picked up, and a projection of the place where it can be placed appears.

📌 Repair
• Press R – the wheel is placed on the ground.
• Approach it and press R again – the repair process begins.

📌 Installation back
• After the repair, press R again and pick up the wheel.
• Bring it to the installation location on the tractor and press R again.

✅ That’s it! The wheel is installed, fully repaired and inflated. You can continue working. 🚜💨

V1.2.5.0
– Fixed a bug when entering a save where the equipment does not yet have swap data and errors about this were poured into the log.
– If you use the FS25_VariableTirePressure mod, the game will prompt you to disable the internal tire inflation mode or disable the mod, in order to avoid strong conflicts between mods. (but I still recommend using the internal wheel inflation system of the dirt mod)
– Some translations have been corrected. (if you want, you can correct the translations for your language and send them in private messages for further updates)
– Compatible with the FS25_VisualMudTracks_v25 mod (using the FS25_VisualMudTracks_v25 mod with mudSystemPhysics is at your own risk)
– By pressing the deflate and inflate buttons, now you need one press for this action, and the air will smoothly begin to deflate or inflate.

V1.2.4.0
– Added a new “Tire Pressure” system. Now you can control the tire pressure, and this completely wedges the mud system, at low pressure there is better cross-country ability. (The mode has been introduced as a test, test it, unsubscribe.)
– Added a whole new block of settings for the mode. “Tire pressure”
– Buttons to control the new mode RCTRL+RALT – open hud, LCTRL + = – download, LCTRL + – – Lower.

V1.2.3.0
– Corrected Hungarian translation. Thanks @ZENT
– In the soil moisture and drying settings block, a parameter has been added to turn off humidity tuning by the mod; if turned off, all humidity will be calculated according to the standard by the game.
– In hood fashion, the display of information before a thunderstorm has been added. (if you use the FS25_thunderstorm mod)

V1.2.1.0
– Code optimization by removing unnecessary unused functions that have been lying around since the beginning of the development of the mod.

V1.2.0.0
– The local humidity mode has been completely redesigned, now it does not have a separate hud. By enabling local humidity mode in our main hud mod, humidity percentages now work locally across the soil.

V1.1.9.0
– A new mode has been added to the mod, determining local humidity. Can be enabled in settings.
By turning on this mode, we have a new hud that shows its soil moisture, and the chances of getting stuck in the mud are already changed to the internal system of the mod, and not to the game logic of humidity.
By default, this mode is disabled. You can enable it in the mod settings, in a separate block.

This mode is still under development and improvement. This version is not final, the update was posted to collect feedback from players.

V1.1.8.0
– Crawler tractors. (which actually have a crawlers block in xml) are now 2-3 times less sensitive to all the dirt.
– Added preset selection to the settings, now you can select the complexity of the mod.
– In some places, script edits were made to make the mod slightly easier even on the highest selected preset. (you can manually adjust the settings yourself as you wish)

V1.1.7.0
– Fixed compatibility issue with the financing mod. Now the settings of our mod appear correctly, even with the financing mod enabled.
– added a whole group of settings to control the speed of soil drying and wetting
– Added the ability to drag the mod hud by clicking on it with the mouse. (you need mods that can enable mouse mode on the screen, or set a button that is convenient for you in the mod settings; to enable mouse mode for dragging hud, it is turned off by default)
– hud settings for everyone on a dedicated server. (now on the Hud server each client chooses separately)

V1.1.6.0
– The mod settings are completely moved to their own new separate tab, so as not to clutter the general settings.
– Faq converted to PDF are inside the mod
– Various minor edits

V1.1.5.0
– Fixed winter slip multiplier. The threshold became from 0 to 2 in the settings. 0 – slippery, 2 not slippery.
– Optimized pieces of code responsible for coloring dirt in sprayType color
– The logic of snow sticking to dirt has been rewritten. (should be more visually pleasing and less expensive)
– Added Czech translation (from player Mapo)

V1.1.4.0
– Now the dirt will be painted in the color of the sprayType of the field, that is, if you have lime on the field, the dirt on the equipment will be whitish in color. (the same works for manure and fertilizer. Can be turned off in the settings in the mud settings block in the fields)
– Also now snow can stick to the wheels (pseudo convention) if there is snow and the temperature is above minus 7, then the snow will stick creating a mesh of dirt with snow. (if it is already minus 8, there will be no mesh itself, only the color of the tire as in the standard)

V1.1.3.0
– Fixed a bug on the servers not found for ‘getContactPoint’.
– Improved the logic of permanent getting stuck, both on dirt terrain brushes and in fields, now when you get stuck, you will receive a notification that you are stuck. (notifications can be turned off in the mod settings)
And now you don’t need to completely pull out the equipment from the field or from the current brush of dirt. It is enough to pick it up and pull it out a few meters and you can move on.
– Added settings (whether to show notification about getting stuck in mud)
– Added Polish translation from player Duch33.

V1.1.2.0
– The standard preset Additional dirt particles has been replaced. (more for new players, or you can reset the mod settings, or select manually) The old particles also remained in the selection, in the settings.
– Added Hungarian translation (from player perec23).
– Added Ukrainian translation (from player sasha007).
– Bug fixed: Previously, if there were dirt brushes under the object asphalt, then the asphalt worked like dirt, now this has been fixed, and there is no longer a reaction on object roads with collisions.
But if your road is terrain decal (without collision), then dirt will work if there are mud and dirt brushes underneath it. in such cases, under such a road, you need to paint with Asphalt or concrete brushes.
– Fixed a bug: Previously, if equipment was lifted over a field in the rain and dragged in the air (with superpower, for example), then the particles flew from under the wheels, even if we did not touch the ground. This has now been fixed.

V1.1.1.0
– added display of time until the end of current precipitation
– Added a slider to the settings for turning on and off the display until the end of the current precipitation
– Added a selection of additional dirt particles for the settings of both dirt modes. (for terrain and fields)

V1.1.0.0
– Now wide wheels are less stuck in the mud. (this can be turned on or off, as well as configured in the mod settings)
Attention! This only works on the actual wheel width as indicated in the registration documents, and not on the visual. In some mods, the wheels are only visually wide.
– The FAQ inside the mod has also changed, the descriptions for the new settings have been added. (only .docx files for now)
– Improved system of mud spitting against slipping.
– The same system of mud spitting from slipping has now been added to the fields. (previously it was only on terrain brushes)

V1.0.9.0
– an item has been added to the settings that includes additional mod settings for each field layer. (you need to turn it on and restart the game, and additional items will appear in the settings)
!!!Attention, after setting the items, it is advisable to hide them back, so as not to catch a drop in FPS in the settings menu.!!!
– A faq folder has been added inside the mod, which now contains short instructions for setting up what they mean and what they do.

V1.0.8.0
– Attempt to improve performance. Disabling calculations for the wheels of vehicles that do not move. (So far only for Terrain Brushes, Fields remain as they are)
– Hail Now counted in Hud precipitation
– The hud now shows what precipitation is expected, until which time is shown.
– Fixed brush cache, if certain terrain layers are not found, spam attempts to cache them should disappear.
– Minor translation corrections

V1.0.7.0
– Fixed a bug where on some maps there was an error when turning on deletion to zero foliage. (now if there are no necessary layers, then we simply ignore this setting)

V1.0.6.0
– Now the mud and dirt layers will not react like dirt in winter (the settings have been added to enable and disable this, as well as adjust the temperature threshold for this parameter)
– The fields also freeze in winter now, and even if it’s wet the mud doesn’t work. (added to the settings to enable and disable this, as well as setting the temperature threshold for this parameter)

V1.0.5.0
– Added a new variable to hud, time until precipitation.
– A switch has been added to the settings whether to display the time until precipitation.
– A switch has been added to the settings: Whether to react to terrain brushes named DIRT as if they were dirt.
(This can help you avoid effects from under the model of the road, asphalt, if DIRT is painted under it with brushes)

V1.0.4.0
– Increased soil drying time after rain
– slightly increased soil wetting time
– Improved hud fashion, added a block for hud
– Slightly adjusted hud position presets
– The logic of the dirt in the margins has been rewritten. Now the humidity percentages are more influential,
that is, if there is 10% humidity on the ground, then the effects of dirt on the fields are minimal, and when the percentage of humidity in the ground increases, then the effects of dirt on the fields increase.
(but don’t forget that in the calculations, the strength of the rain is also taken into account, which means that if the rain is 100% and the humidity is still zero (since the game does not only rely on humidity),
then the effects will already begin to take effect.
– It was decided to cut out the settings of each individual layer of the earth. (they clogged the settings menu and as a result the FPS in the settings menu dropped, “was less”)
– The reset slider has been removed from the settings menu. All that’s left is the (X) button at the bottom of the settings menu

V1.0.3.0
– Improved hud mod. (Thanks to Sergey RMG)
– Some aspects of the script have been reconfigured. (now dirt on all types of field soil should stick normally)
– In the game settings, an item for selecting hud fashion icons has been added
– Added selection of the position of the mod icons by setting coordinates on the screen
– Added Spanish translation

Known Issues: Some players do not have mod settings in the general settings. (It’s not clear why yet. I didn’t find a conflicting mod)

ATTENTION! IF YOU WANT TO FEEL THE UPDATE CHANGES, BE SURE TO RESET THE MOD SETTINGS BY CLICKING IN SETTINGS,
RESET BUTTON, OR DELETE THE FILE MudSystemPhysics.xml FROM modSetting/

V1.0.2.0
– Added support for terrain brushes with water in the brush name. for example waterPuddle (such brushes work like dirt and outside the rain, this is a note for map authors)
– Added flexibility in settings for each field ground layer. (all 15 profiles)
– Fixed cases when under the fields on the maps there were mud brushes (terrain brush mechanics), the game applied two values at once as a field and as a terrain brush for mud. What could have caused the inappropriate behavior? (now if this is a field, then the field mechanics work)
– Added Italian translation from version 1.0.1 from player iguana32

Known Issues: Some players do not have mod settings in the general settings. (It’s not clear why yet)

V1.0.1.0
– the condition of contact with the terrain has been improved. (to avoid dirt particles on bridges) (if the maps you play under asphalt have dirt or mud brushes, there will be dirt effects, alas and ah)
– Minor color adjustment for additional dirt particles
– Reconfiguration of hidden physics values (for balance)
– An attempt to teach how to depict dirt when in contact with water.
– An attempt to correct shaking (jumping and jumping) along narrow paths, when contact with the terrain brushes quickly changes.
– Fixed the problem of small wheels. (there was a bug that they increased to a radius of 0.295, the limit value for wheels)
– Getting in and out of mud has become smoother.
– Added a separate button to the bottom of the settings to reset settings.

ATTENTION! IF YOU WANT TO FEEL THE UPDATE CHANGES, BE SURE TO RESET THE MOD SETTINGS BY CLICKING IN SETTINGS,
RESET BUTTON OR DELETE THE FILE FROM MudSystemPhysics.xml modSetting/